Coilovers, corner weights and the first proper alignment

October 26 · 7 min read

The stock dampers had about 180,000 km on them. On the street the car felt "fine", which is exactly how worn dampers fool you: the change is so slow that you stop noticing the float over bumps and the lazy turn-in.

What went in

An entry-level coilover kit with 8k front and 6k rear springs. Nothing exotic — the goal was predictable behaviour on a track day, not lap records. Installation took one long Saturday, mostly fighting a seized rear lower bolt.

Ride height first, then everything else

I set the ride height roughly 25 mm lower than stock, keeping enough thread to adjust later. Lowering too far on a budget kit just moves you onto the bump stops, and that is worse than stock.

The alignment matters more than the parts

Final numbers: −1.8° camber front, −1.3° rear, zero toe front and a little toe-in at the rear for stability. The difference after the alignment was bigger than the difference from the coilovers themselves.

FrontRear
Camber−1.8°−1.3°
Toe (total)0.0°+0.2° in
Damping (clicks from soft)86

Lessons

Soak every bolt in penetrating oil the night before. Measure ride height at the hub centre, not the fender lip. And budget for the alignment from the start — it is not optional.

← Back to the journal